Make Curtain Rod As The Way Given By Curtain Pole Manufacturer

Curtain pole manufacturer gives detailed steps to make diy curtain rods.

STEP 1
Measure your window, then cut the 1-inch wooden dowel to a length at least 5 inches longer than your window is wide. Sand it completely to remove splinters.

 

Curtain pole manufacturer gives detailed steps to make diy curtain rods.

STEP 1
Measure your window, then cut the 1-inch wooden dowel to a length at least 5 inches longer than your window is wide. Sand it completely to remove splinters.

Create finials for your DIY curtain rods from wooden drawer knobs that are slightly larger than 1-inch in diameter. Ours are rather simple in style, but when you shop the drawer knob selection at your local hardware store, you’ll see that you have many options here and can go as fancy as you like. Then, to attach, you’ll apply contact adhesive to one end of the dowel and the end of the knob that typically screws into drawers; wait a few seconds and press them together. Once the glue has dried, repeat on the other side of the curtain rod.

STEP 2
Lay the DIY curtain rod, brackets, wooden rings, and the wooden lamp sockets (without the cords) out on top of a plastic sheet or old newspaper, then spray-paint them a copper. No copper accents in the room? No problem! You can choose whatever metallic hue best fits with your interior design—silver, gold, even black metallic—to give the wooden fixtures a high-end look. Wait until the first coat is dry to flip all of the items and apply a second coat. Repeat until you’ve completely covered all pieces.

STEP 3
Stand on a ladder and use a cordless drill to fasten the curtain brackets on the wall, one on each side of the window. Fake a larger window and a higher ceiling by positioning these brackets (and the DIY curtain rod) between 4 and 6 inches above the window.

STEP 4
Hang your curtains on the rod, and place it back on its wall-mounted brackets. Depending on the type of brackets you’ve chosen, you may need to use an additional screw at each end to firmly hold the rod in place; refer to the manufacturer instructions for the bracket, if you’re not certain.

STEP 5
Repeat steps 1 through 4 to make as many DIY curtain rods as there are windows in the room. After you’ve outfitted each glass pane with a set of window treatments, you can use the money you’ve saved by DIYing rather than buying to create matching curtain tiebacks for each fabric panel.

Grab a spray-painted wooden curtain ring, a wooden lamp socket in matching color, and rope. Cut 1 yard of rope, fold it in the middle, and pass its rounded end through the bottom of the socket. Knot the loose ends beneath the socket.

STEP 6
Pass the looped rope through the ring, wrap it down, and then pass the socket through the loop. Pull the wooden lamp socket so that the rope tightens around the ring and the knot slides into the socket itself.

STEP 7
Screw a cup hook onto the wall next to the window about 6 inches above the windowsill with the hook facing up to hold the doubled-up rope. You can make a knot around the hook to prevent the rope from slipping.

Repeat steps 5 through 7 to make additional tiebacks for every curtain panel.

STEP 8
When you’re ready to open the curtains and let the sunshine in, simply pull back your fabric panel and wrap the two ends of the rope tieback around it so that the socket passes through the ring. The simple yet distinctively modern shapes strung around the lower third of your shower curtains balance the room’s DIY curtain rods for a completely chic window treatment.

As Curtain rods can be customized to the manufacturer,welcome to your come and purchase!

 


Fenghao Tommy

52 Blog Posts

Comments