1. The dust, straw and other debris inside and outside the Corn Sheller should be removed as soon as possible during the idle period. Rinse the whole machine with pressure water and dry it. 2. Store the Corn Sheller in a dry and ventilated garage with high terrain. Use wooden pillows to support the frame near the tires. The four support points should be on the same level to avoid deformation of the frame. 3. Remove all transmission belts, wipe them clean, apply talcum powder, mark and place labels, and hang them on the garage wall for storage. Remove all chains, clean them with diesel oil, and store them in a dry and ventilated place. 4. Remove the battery, fully discharge the battery at a discharge rate of 20 hours, pour out the electrolyte, and repeatedly wash the inside of the battery with distilled water until the distilled water poured from the battery has no sour smell. Put the battery upside down on two pieces of wood, drain the water and let it dry. Tighten the filler cap tightly and save it. 5. Remove the load on all safety clutch springs and some other springs to avoid fatigue deformation of the springs and affect its working performance. 6. Clean the cutter and sprocket, and apply anti-rust oil to prevent corrosion. Check the damage of the parts of the working parts, repair or replace them according to the damage, and fully lubricate the parts with butter.
In order to ensure the harvest quality of corn ears and the effect of straw treatment, reduce the fragmentation rate of ears and grains, and meet the qualified rate of returning straw to the field, the qualified rate of root stubble and the requirements of straw cutting silage, Knapsack Fertilizer Machine must meet 3 operations condition. 1. The harvest of corn with straw silage should be carried out in a timely manner, and the combined harvesting operation should be carried out when the corn ears are just mature and when the straws gradually turn yellow and dry. At this time, harvesting increases the nutrients and moisture of the straw, which is beneficial to silage. 2. The harvesting of corn with straws returned to the field should be carried out at an interval of 3 to 5 days after the fruit kernels are mature, so that the corn kernels are fuller and the corn cobs have low moisture content, which is conducive to the peeling operation. The corn stalks slowly turn yellow, and the reduction in water content is more conducive to crushing the stalks and reducing power loss. 3. According to the size of different plots and the actual situation of the integration of agronomy and agricultural machinery, its planting distance and operation quality requirements, choose suitable machinery and tools, and plan and formulate harvesting routes.